Body Sculpting Device B-333 Manual Device Operating Principle EMS: The device sends electrical impulses to stimulate specific points in the body, which helps to: • Improve blood circulation • Accelerate metabolism (burning) • Remove toxins from the lymphatic system • Exercise muscles • Relieve various body pains • Aid in weight loss • Tighten skin • Enhance breast lift The goal is to achieve a healthy and toned body. ⸻ EMS Device Screen Buttons • Time Button Maximum: 60 minutes • Mode Button There are 12 different operating modes • Start / Stop Button • Output ports 1 to 10 Each port can be operated individually or together • Intensity Maximum 60 levels ⸻ Operating Steps 1. Connect the power cord to the rear input of the device. 2. Press the STOP / WORK button to turn on the device. 3. Using the + and − buttons below the digital display, you can set the time. 4. Using the + and − buttons, you can select the mode. 5. Press the ON / OFF button for each port to activate it (there are 10 ports). 6. After finishing, turn off the main power switch. ⸻ Vacuum Device Screen Buttons • Time Button Maximum 60 minutes • Heat Intensity Button Maximum 10 levels ⸻ Vacuum Operating Method 1. Connect the power cord to the back of the device. 2. Press the power button. 3. Use the + and − buttons to set the time. 4. Use the + and − buttons to set the heat intensity. 5. After finishing, turn off the device using the main switch. ⸻ Important Note When using the Vacuum lifting device: • Press the opening on the handle before placing it on the body, then start suction. ⸻ Warnings and Instructions 1. Choose the size of the electrodes according to the area size: • Large electrode for large areas • Small electrode for small areas 2. Before use: • Apply conductive gel or water to the skin and electrodes. • Do not use oily liquids. • Ensure good contact between the electrodes and the skin. • If the skin is dry or contact is poor, tingling or pain may occur. 3. Do not place two electrodes near the heart because the current may pass through the heart and cause discomfort. 4. Before treatment: • Warm the area with steam for 10 minutes. • Apply a special lotion. • Massage the area for 5-10 minutes. • Wipe the skin with a damp towel. • Gradually increase the current intensity until the user feels a light sensation. The intensity should be within the user's comfortable level. 5. The device is prohibited for use in the following cases: • Pregnant women • People with metal implants in their body • Those with acute or purulent infections 6. It is preferable to avoid using it on the face or use it with extreme caution. ⸻ Accessories • Body electrodes: 10 pairs • Breast electrodes: 1 pair • Cables: 12 pieces • Face electrodes: 1 pair • Vacuum handle: 1 piece • Face mask: 1 piece